Programming a Genie keypad Garage Door Repair Parma OH opener is a simple and straightforward process that can be done in a few easy steps. In this guide, we’ll walk you through the steps required to program your Genie garage door opener keypad.

Before we begin, it’s important to make sure that you have the correct model of the Genie keypad garage door opener. Most models will have a “Learn” button on the motor unit that controls the garage door opener. If your model has this button, you’re good to go.

Step 1: Clear the Memory

The first step in programming your Genie keypad garage door opener is to clear the memory. This ensures that any previously stored codes are erased and that the keypad is ready to accept new codes.

To clear the memory, locate the “Learn” button on the motor unit of your garage door opener. Press and hold this button for about 10 seconds until the indicator light on the motor unit turns off.

Step 2: Enter the PIN

Next, you’ll need to enter the PIN code that you want to use to open your garage door. This code can be any combination of numbers between three and eight digits.

To enter the PIN, locate the keypad on your Genie garage door opener. Enter your desired code using the numbered buttons on the keypad.

Step 3: Program the Opener

With the PIN entered, it’s time to program the garage door opener itself. To do this, you’ll need to press the “Learn” button on the motor unit once again.

As soon as you press the “Learn” button, the indicator light on the motor unit will begin to blink. This indicates that the garage door opener is in programming mode.

Once you see the blinking light, go back to the keypad and press the “Enter” button. This will send the code you just entered to the garage door opener.

If the code was accepted, the indicator light on the motor unit will flash once. If the code was not accepted, the indicator light will flash twice. In this case, repeat the previous steps to re-enter the code.

Step 4: Test the Opener

With the code programmed into the garage door opener, it’s time to test it out. Stand back from the garage door and press the “Enter” button on the keypad. The garage door should begin to open.

If the garage door doesn’t open, double-check that you entered the correct PIN code and that the programming was successful. If you continue to have issues, consult the user manual or contact Genie customer support for assistance.

Step 5: Add Additional Codes (Optional)

If you want to give other people access to your garage, you can program additional PIN codes into the Genie keypad garage door opener. To do this, simply repeat the previous steps for each additional code you want to add.

Keep in mind that each additional code will require a separate button press on the “Learn” button of the garage door opener. For example, if you want to add two additional codes, you’ll need to press the “Learn” button three times in total.

Conclusion:

Programming a Genie keypad Garage Door Repair Parma OH opener is a simple and straightforward process that can be done in a matter of minutes. By following the steps outlined above, you can easily program your garage door opener to recognize your desired PIN code and start using it right away. With the ability to program multiple codes, you can also give other people access to your garage without having to give them a physical key or remote control.

Parma Garage Door Repair

3710 Albertly Ave #8, Parma, OH 44134

440-762-6587