Replacing Garage Door Repair Haslet TX can be a challenging and potentially dangerous task if not done correctly. These springs are responsible for counterbalancing the weight of the garage door, making it easier to open and close.

If you’re confident in your DIY skills and have the necessary tools, you can follow these steps to replace garage door torsion springs safely. However, if you’re unsure or uncomfortable with this task, it’s advisable to hire a professional.

: Gather Necessary Tools and Materials

Before you begin, make sure you have all the required tools and materials:

  1. Safety glasses and gloves
  2. Adjustable wrench
  3. Vice grips or locking pliers
  4. Ladder
  5. Winding bars
  6. Tape measure
  7. Socket set
  8. New torsion springs (Ensure you get the correct size and type)
  9. A friend or family member to assist you

: Disconnect the Garage Door Opener

For safety, disconnect the power to your garage door opener. You can typically do this by unplugging it from the outlet or turning off the circuit breaker.

: Lock the Door in Place

Use locking pliers or vice grips to secure the garage door in a closed position. This will prevent it from accidentally opening while you’re working on the springs.

: Release Tension from Old Springs

Locate the winding cone on the spring, which is usually at the center of the torsion shaft. Insert one of your winding bars into one of the holes on the cone. Slowly turn the winding cone counterclockwise to release the tension from the old spring. Do this for both springs, if applicable.

: Remove Old Springs

Once the tension is released, use a socket set to remove the bolts securing the springs to the torsion shaft. Carefully slide the old springs off the shaft and remove them.

: Measure and Order New Springs

Measure the length, inside diameter, and wire size of the old springs. This information is crucial for ordering the correct replacement springs. Purchase new springs from a reputable supplier, ensuring they match your measurements.

: Install the New Springs

Slide the new springs onto the torsion shaft and secure them with the bolts. Make sure they are evenly spaced and centered on the shaft.

: Wind the New Springs

Using your winding bars, turn the winding cone clockwise to wind the new springs. Follow the manufacturer’s instructions for the number of turns needed to achieve the correct tension. Be cautious, as winding the springs can be dangerous if not done correctly. Always keep your body clear of the spring cone.

: Test the Door

With the springs properly tensioned, unlock the door and carefully test its operation. Make sure it opens and closes smoothly. If there are any issues, such as the door being unbalanced or making unusual noises, stop and seek professional help.

: Reconnect the Garage Door Opener

Reconnect the power to your garage door opener and test it to ensure it operates correctly.

: Safety First

Remember to wear safety glasses and gloves throughout the entire process. Torsion springs are under high tension and can be dangerous if mishandled. If you have any doubts about your ability to safely replace the springs, it’s best to hire a professional technician who has the necessary experience and equipment.

In conclusion, replacing Garage Door Repair Haslet TX is a challenging task that requires careful attention to detail and safety precautions. If you’re not confident in your abilities or feel uncomfortable, it’s always best to hire a professional to do the job safely and effectively. Safety should be your top priority when working with garage door springs.

Haslet Gates & Garage Doors

817-482-3394